avatar_frank2056

1/35 Lunar Hopper

Started by frank2056, Yesterday at 09:04:10 PM

Previous topic - Next topic

frank2056

This is based on Alex Schomburg's cover artwork for the November 1964 issue of Amazing Stories. The artwork for the cover story is of a completely different design:



Ignore the fact that the astronaut's face plate seems to be open. Nothing like fresh vacuum in your face while cruisin' the lunar plains! It took a while to figure out how this hopper is supposed to be controlled. I think the astronaut uses his feet (!) to swivel the engine port and starboard, and maybe in pitch. No idea how yaw would work. I had to make some guesses about the hidden structure, but here's the first 3D iteration:

Not a perfect match, but OK-ish:



I used a scaled drawing of a seated astronaut to get an idea of where the seat and controls should be placed. It's slightly different than the artwork.







I made some 1/35 diamond plate. It should be interesting to see if it prints:



It looks like I'll be able to fit 4-6 of these on my Saturn 8K's build plate, but the vehicle disappears inside a forest of supports.


kerick

Hey! He's got a bucket seat and a cup holder in front of the handlebar!  :wacko:
I'd say that was a very good representation of that artwork.
Obviously the faceplate is up so you can see his mug. Just before he wheezes out his last breath.  :o  Just like every movie astronaut and deep sea diver always has lights on inside the helmet. Makes it difficult at best to see outside the helmet but it looks good in the movie.
" Somewhere, between half true, and completely crazy, is a rainbow of nice colours "
Tophe the Wise

NARSES2

Do not condemn the judgement of another because it differs from your own. You may both be wrong.