1/72 3d Printed Fairey ER.103C or Fairey Delta 3 "Small"

[scautomoton]

Wow - looks great for a prototype print.

I've been using the perforated rafts and they really make it easier to remove the builds from the plate.

Yeah, I find it easier to remove the skates in general. The tapered edge is nice for using a scraper to start to lift and peel it from the build plate, then it just pops off. However, for large surface area stuff I go with the grid plate, otherwise the skates snap.

[Mossie]

This looks lovely,  like a high end resin kit. 

[PR19_Kit]

 It IS a high end resin kit!

[scautomoton]

I think it more accurate to state "it aspires to be a high-end resin kit"!

[Glenn Gilbertson]

Tempting - really tempting!

[NARSES2]

It does look rather tasty, I could well be tempted, and it doesn't even have a propeller     

[PR19_Kit]

It does look rather tasty, I could well be tempted, and it doesn't even have a propeller     

But as this is WhiffWorld you can fit one Chris.   

[scautomoton]

It does look rather tasty, I could well be tempted, and it doesn't even have a propeller     

But as this is WhiffWorld you can fit one Chris.   

Like a Fairey equivalent of the Thunderscreech!

[PR19_Kit]

Like a Fairey equivalent of the Thunderscreech!

Now there's a thought, we never did go down that route in the UK, did we? Could be a whole new area of Whiffing............. 

[kitbasher]

Like a Fairey equivalent of the Thunderscreech!

Now there's a thought, we never did go down that route in the UK, did we? Could be a whole new area of Whiffing............. 

Sweep back those Wyvern wings and.......

[PR19_Kit]

Sweep back those Wyvern wings and.......

Indeed so, I wonder if Colin's Super Hunter wings would fit? 

[kitbasher]

Sweep back those Wyvern wings and.......

Indeed so, I wonder if Colin's Super Hunter wings would fit? 

Dunno, but looking at the Thunderscreech a Hunter could be the basis:
- Hunter fuselage
- T-tail
- Hawker P.1109 nose (maybe extended?), radome becomes the prop spinner
- Vampire intakes
- early Hunter wings (i.e. minus dog-tooth extensions)

[PR19_Kit]

And longer landing gear to clear the prop?

[kitbasher]

And longer landing gear to clear the prop?

Slightly longer, but not by much - Thunderscreech prop blades are, after all,, quite stumpy.

[PR19_Kit]

Yes, you'd need to clip the Wyvern prop blades a bit though and stretch the nose leg perhaps? The 'Screech sat at quite a nose-up angle.