What if

Picture Post => Current and Finished Projects => Figures, Cars, Etc => Topic started by: nönöbär on October 13, 2019, 06:11:41 am

Title: Babarian Girl, 1/12
Post by: nönöbär on October 13, 2019, 06:11:41 am
This is the first attment to print a figure with the SLA Printer.
It almost worked, but the right arm did not come out very well (I guess I used not enough support there). So I had to removed it and reprinted it with the FDM printer - in the end it worked somehow.

Printed with an Anycubic Photon, hand painted with Revel Aqua Colour.

(http://www.german-navy.de/web/ScaleModels/ScaleModel20191013100310.jpg)
(http://www.german-navy.de/web/ScaleModels/ScaleModel20191013100311.jpg)
(http://www.german-navy.de/web/ScaleModels/ScaleModel20191013100312.jpg)


The following 3D-Model was used:

BARBARIAN GIRL by boris3dstudio (Published on May 18, 2019) https://www.thingiverse.com/thing:3639225/ (https://www.thingiverse.com/thing:3639225/)
Title: Re: Babarian Girl, 1/12
Post by: NARSES2 on October 13, 2019, 06:16:48 am
The question is : Would I want to meet her on a dark night or not ?  ;) ;D

Nice job
Title: Re: Babarian Girl, 1/12
Post by: nönöbär on October 13, 2019, 06:18:07 am
The question is : Would I want to meet her on a dark night or not ?  ;) ;D

Nice job

I guess better not.... My engineer was too afraid and did not want to get on the photos.
Title: Re: Babarian Girl, 1/12
Post by: NARSES2 on October 13, 2019, 06:36:29 am
 ;D ;D