What if

General Modelling Forum => General Modeling topics => Topic started by: Cobra on December 26, 2010, 11:45:56 AM

Title: Carrier Deck Dio Query
Post by: Cobra on December 26, 2010, 11:45:56 AM
Hey Guys, with a Few Ideas in Mind, Can Anyone Tell What would work for the Decking/Surface for a Good Carrier Launch Diorama? Was thinking of going 'GA' with a Blackbird,Etc. Could use Any Input. What Say You? Thanks for Looking.Dan
Title: Re: Carrier Deck Dio Query
Post by: Army of One on December 26, 2010, 01:51:20 PM
Depending on scale.....how about a sheet of really fine grit 'wet n dry'.........punch out some holes at relevant places and drill a shallow hole on the base you glue the paper to.....tie down points.....a google search should show pics of them....but you probably done that already.......H
Title: Re: Carrier Deck Dio Query
Post by: pyro-manic on December 26, 2010, 02:00:17 PM
You can buy them from various places online, but I can't remember them offhand. I'm sure someone will be along with an appropriate link shortly. Alternatively, find some decent photos and print them off, then stick them to the base of your choice.
Title: Re: Carrier Deck Dio Query
Post by: beowulf on December 26, 2010, 02:47:43 PM
Quote from: pyro-manic on December 26, 2010, 02:00:17 PM
You can buy them from various places online, but I can't remember them offhand. I'm sure someone will be along with an appropriate link shortly. Alternatively, find some decent photos and print them off, then stick them to the base of your choice.

these ones?

http://www.scale-rotors.com/forum/topic/printable-carrier-decks
Title: Re: Carrier Deck Dio Query
Post by: ChrisF on December 26, 2010, 07:09:53 PM
some of the pics further down this page might be useful too :)