Might be getting good at this. Decided on a metal finish after the intakes had been glued on, so how the hell do I get foil on the fuselage behind them? Eyeball it, cut a rectangle of foil, cut a V notch in it to get around fuselage attachment, test fit, adjust with sharp blade and curved scissors, test fit again, thank eyeballs for doing good work, then apply glue, wait until it's a little less tacky than normal, easier to adjust by sliding, then plop it in, adjust position, and burnish down. Came out pretty good on each side. Still some trimming and burnishing to do but the hard part is over with.
Musical accompaniment to stoke the 'screw it and forge ahead!' attitude is courtesy of a metal/goth playlist that someone put up. Cradle of Filth, Ghost, Type O Negative, Dimmu Borgir, Behemoth, a long list of throaty screamers. Includes the infamous uncensored video of COF performing From the Cradle of Enslave. Look that up at your peril.
